Look Solutions Viper NT

DMX 512 as standard

The VIPER NT can be controlled via DMX 512. The connection is done with 5pin-XLR-plugs.
The DMX start address can be adjusted and saved via the control panel.

The machine can also be controlled with analog (0 - 10 V) via a lighting desk or via XLR-remote (option). This connection is done with 3pin-XLR-plugs.

A stand-alone-mode is also possible. The adjustments are done directly at the machine. A short press at the start button makes the machine run. Therefore a permanent pressing of the start button is unnecessary.

Internal timer

With the internal timer the fog time can be exactly adjusted in seconds, the wait time in minutes and the output in %.

Control panel

The control panel with LED-display, simple symbols allow for easy operation. It also protects the control buttons against dirt.

Finest adjustments of the output

Digital technology makes fine adjustment of the pump possible. In steps of 1% the output can be adjusted from 0 - 99%. Thus, any desired effect from a tiny fog-cloud to the thickest fog can be produced. This enables the viper nt to be used in both small and large locations.

Advantages

DMX as standard, analog and stand-alone-mode
Internal timer
Fog output adjustable in steps of 1% (0 - 99%)
Continuous output
Easy handling
Powerful output
Made in Germany

Technical data

Procedure	Vaporizing fog generator
Power requirement	1300 Watt
Voltage	230 V / 50 Hz 120 V / 60 Hz
Warm up time	approx. 7 min.
Fluid consumption at max. output at continuous output	120 ml/min. . 35 ml/min.
Fluid tank capacity	5 Liter
Fog output	adjustable in 99 steps
Output projection	max. 15 m
Fogging time at max. output at < 50% output	approx. 40 sec. Continuous output
Control	DMX 512 0 – 10 V analog Stand-alone-Mode Radio remote (Option))
Temperature control	Microprocessor controlled
Overheating protection	Heater block/Thermostat Pump/Thermal switch
Dimensions (L x W x H)	47 x 23 x 24 cm
Weight without bottle	approx. 8,3 kg